| 张宣超.斗式提升机粉料运动离散元仿真分析与研究[J].水泥工程,2024,37(4):48-51 |
| 斗式提升机粉料运动离散元仿真分析与研究 |
| Discrete element simulation analysis and research on powder movement of bucket elevator |
| |
| DOI： |
| 中文关键词: 斗式提升机,离散元仿真,回料率,流动特性 |
| 英文关键词: bucket elevator,discrete element simulation,return rate,flow characteristic |
| 基金项目: |
|
| 摘要点击次数: 140 |
| 全文下载次数: 0 |
| 中文摘要: |
| 本文以斗式提升机为模型，采用DEM（Discrete Element Method）算法对粉料在提升机内运动过程进行离散元模拟仿真，分析粉料颗粒在其内部的运动轨迹，得出粉料粒径以及料斗数对提升机回料率的影响规律，为提升机的结构优化提出理论性的指导。结果表明：（1） 均匀粉料粒径越小，机尾回料越严重，并得到回料量与粒径之间的关系式；（2） 斗数增加可以提高提升机输送效率，降低粉料回料量；（3） 随着粉料粒径的增大，料斗填充率呈现先增大后降低的趋势，并在4 mm粉料粒径时得到峰值，填充率达到69%。 |
| 英文摘要: |
| This article takes a bucket elevator as a model and uses the Discrete Element Method (DEM) algorithm to simulate the motion of powder particles inside the elevator. The motion trajectory of powder particles inside the elevator is analyzed, and the influence of powder particle size and hopper number on the return rate of the elevator is obtained. Theoretical guidance is proposed for the structural optimization of the elevator. The results showed that: （1） The smaller the uniform powder particle size, the more severe the machine tail return, and the relationship between the return amount and particle size was obtained;（2） Increasing the number of buckets can improve the conveying efficiency of the elevator and reduce the amount of powder material returned; （3） As the particle size of the powder increases, the filling rate of the hopper shows a trend of first increasing and then decreasing, and reaches its peak at a particle size of 4 mm, with a filling rate of 69%. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
|
|
|