| 陈黎东,李晓平,王复光,贲道春.浅谈回转窑筒体周长和圆度要求及测量方法*[J].水泥工程,2018,31(2):47-50 |
| 浅谈回转窑筒体周长和圆度要求及测量方法* |
| Discussion on Requirements and Measuring Methods of Rotary Kiln Shell Circumference Difference and Roundness |
| |
| DOI： |
| 中文关键词: 回转窑 标准 周长差 直径差 圆度 检测方法 |
| 英文关键词: rotary kiln standard circumference difference diameter difference roundness inspection methods |
| 基金项目: |
|
| 摘要点击次数: 1985 |
| 全文下载次数: 1 |
| 中文摘要: |
| 通过对GB/T 32994—2016水泥工业用回转窑国家标准中有关筒体最大直径与最小直径差要求和测量方法的研究，分析出标准中相关技术要求和检测方法的存在问题和不足，否定了标准规定的筒体内径公差要求和相关的检测方法，并根据实际需要提出了筒体周长差要求和与筒体最大直径与最小直径差要求等效的圆度要求建议，同时介绍了相关建议要求的相应测量方法。 |
| 英文摘要: |
| Through researching requirements and measuring methods of the difference between shell maximum and minimum diameters in GB/T 32994—2016 cement industry rotary kiln national standards, analyses the problem and deficiency of relevant technical requirements and inspection methods in the standards; denies shell inner diameter tolerance requirement specified in the standard and relevant inspection methods; makes suggestions of equivalent roundness requirement of shell circumference difference requirement and shell maximum & minimum diameter difference according to actual requirements. Meanwhile, introduces corresponding measuring methods of relevant suggestions and requirements. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |