| 张国庆,李慧茹,吴丽娜.Φ1.8 m×1.4 m辊压终粉磨系统的调试[J].水泥工程,2014,27(3):34-35 |
| Φ1.8 m×1.4 m辊压终粉磨系统的调试 |
| Debugging of Φ 1.8m × 1.4m roll finishing grinding system |
| |
| DOI： |
| 中文关键词: 辊压机 终粉磨系统 单机试车 联动试车 试生产 |
| 英文关键词: roller press finishing grinding system single commissioning linkage no-load test trial production |
| 基金项目: |
|
| 摘要点击次数: 1089 |
| 全文下载次数: 0 |
| 中文摘要: |
| 2013年鹿泉金隅鼎鑫水泥有限公司对能耗高的Φ4.6 m×13.5 m原料磨实施Φ1.8 m×1.4 m辊压终粉磨的节能技改，改造后的辊压机终粉磨系统一次性投产成功，运行情况良好。介绍了该系统启动前的准备工作（单机试车和联动空载试车）以及投料试生产和正常生产操作要点，最后还介绍了生产过程中出现的问题及解决方法。 |
| 英文摘要: |
| In 2013, Luquan Jingyu Dingxin Cement Co.,Ltd. rebuilt its high-energy-consumption Φ4.6 m × 13.5 m tube mill raw mill system to energy-saving Φ1.8 m × 1.4 m roller press finishing grinding system, and the new system had been put into production sucessfully and the running condition was good. The preparation work before start-up(single commissioning and linkage no-load test) and the operation points of trial and normal production were introduced as well as the problem solutions in production. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |